November 2020
Bridging the DC relay …
So I can test the flashers without starting the engine.
Electronic flasher relay …
That can handle LED flashers.
12 volt power socket …
Connected directly to the battery terminals so it can also be used to charge the battery.
Front axle protectors installed …
And the new bushes was fitting perfectly !
Handle bar risers installed …
20 mm higher than standard – no need to extend any cables 🙂
Lathe work finished …
20 mm higher handle bar risers and adapters for the KTM front axle protectors.
Drawings for the lathe …
Adapters for the front axle protectors, and handle bar risers.
Installing a speed sensor …
For the Gipro gear indicator.
Garmin Zumo XT installation …
Using the new brackets.
